英國-creek audio - 產品介紹
Voyage i20 建議售價/$
下載相關文件
Voyage i20
Integrated Amplifier + DAC
Power output @ 1% THD 120 Watts into 8 Ohms, both channels
Power output @ 1% THD 240 Watts into 4 Ohms, both channels
Power output @ 1% THD 480 Watts into 2 Ohms, one channel
Power output tolerance Voltage stabilisation enables repeatable power output regardless of mains voltage or load. Current limited
Continuous max output current >10A (sine wave), Current limited
Peak output current +/-26 Amps into 0.5 Ohm load for 100ms – current limited
THD and Noise <0.002% – 20 Hz to 20 kHz @ 2/3 rated power 8 Ohms
Signal to Noise Ratio 102dBA Line input
Frequency Response 1Hz to 100 kHz, +/-2dB
Power amp gain 33.4dB (x 47) un-balanced
Pre-amplifier analogue gain 0dB (x1) default.
Optional pre-amp gain or bypass 3dB, 6dB, 9dB, 12dB, pre-selectable on inputs 1 to 4
Input sensitivity 659mV for full power into 8 Ohms with 0dB pre-amp gain
Crosstalk >80dB at 1 kHz
DC offset < +/-5mV
Pre-Amp Inputs 4 x RCA (un-balanced) and 1 x XLR (balanced)
Pre-amp outputs 1 x RCA (unbalanced) and electronically buffered
Pre-amp output impedance 100 Ohms
Plug-in Phono options Input 1 changes to Phono with Sequel mk4 MM Phono fitted
Digital inputs 2 x SPDIF Co-Axial – (192kHz, 24-bit)
2 x TOSLINK optical – (192kHz, 24-bit)
USB class 2 audio PCM up to 384kHz, 32-bit. DSD 64 and 128
Bluetooth aptX HD
IR BUS IN External IR sensor extender
IR BUS OUT Daisy chain to another Voyage device
Loudspeaker Outputs 4mm binding posts with rear and side entry, plus spade lug
Speaker output impedance <0.02 Ohms 20Hz to 20 kHz (Damping factor >400)
Headphone Output socket 6.3mm stereo jack socket
Headphone output impedance <22 Ohms, suitable for headphone 12 – 600 Ohms
Mains voltage range
230V nominal. Working range – 170V – 265V AC – 50Hz
115V nominal. Working range – 85V – 140V AC – 60Hz
Factory set to either 230V or 115V. Not user adjustable
Mains fuse type and rating T10AL 250V – 5 x 20mm glass cartridge fuse
10 Amp, Time-lag, or Anti-surge, rated at 250V
Ground connections Turntable grounding post next to Line 1 / Phono
Ground Lift A 2-way switch is located under the chassis on the right
Finish colours Silver or Black front panel. The outer cover is black
Power Consumption Idle, Max, Standby <20 Watts, 600 Watt, 0.5Watts
Auto Standby The amp will switch off after 30 minutes with no signal
Auto Standby Menu Status and options controlled in Menu
Power supply fuse T10AL 250V = 10 Amp, Time-Lag, rated at 250V, 5 x20mm
Weight 9kgs (20 lbs) net
Size W/H/D 43 x 8 x 35 cm (17 x 3 x 13.8”) including feet, knobs, and terminals
https://www.creekaudio.com/products/integrated-amplifiers/voyage-i20/